STANDARD CERAMIC FOR WIND SYSTEM - SDEC 220

Being extremely small, this ceramic is basically used for very specific experimentations.
Its mounting (on nylon capillary 3×1,5mm) demands great care. Warning : because of its tiny inside diameter, it might be difficult to drain air bubbles out of the tensiometric system. You should use it in the laboratory only where it is easier to re-saturate the ceramic.

Air entry value : 1,5 Bar.
Pore size : about 1,5 micron.
Hydraulic conductivity : 5 . 10 -7cm.s-1(*).
Weight : 1 gr.
Dimensions (**) :
Outer diam. : 2,10 mm.
Total height : 20,00 mm.
FRAGILE
(*) K is an average value calculated against a sample of 100 ceramics of the same type.
(**) Tolerances on diameter
dimensions : ± 0,5 mm.

The standard set

The porous ceramics can be ordered individually or or fixed to a tensiometer tube for WIND system

Main Menu